Testing Water Heater Element For Continuity

If continuity is broken the heating element is bad and needs to be replaced. Turn off the electrical power to your water heater at the main electrical panel.

Testing For Ground On Water Heater Elements Electric Water Heaters Water Heaters Plumbing Repair Topics

Remove the access panel cover and insulation from the top or bottom water heater element described above Connect the alligator clip or test terminal of your continuity tester to one terminal of the heating element.

Testing water heater element for continuity. Basically in order to test a heating element with a multimeter you can use the continuity test or the resistance test mode. With either a digital or analog multimeter make sure the probes are connected to the multimeter on one end and with the free ends make contact with each of the open terminals on the heating element. The meter should read 0.

If you have a voltage stick you can use that as well. Test Water Heater Elements for an Electrical Short IMPORTANT. Continuity means that there is no break in the electric current between two connection points.

But if there is no reading check its power source. Remove the insulation and disconnect the electrical wire at the terminal and use your multimeter to test the electrical flow. This video demonstrates how to test a heating element on a water heater.

There should be two panels on your water heater an upper and lower. Remove the water heaters access cover panel and insulation from the upper water heater element. Using the multimeter connections touch the top to legs at the same time.

Turn off power at the water heater circuit at the main electrical panel. Remove the upper access panel screws first on the electric water heater with a screwdriver. Before handling anything on the thermostat use a multimeter to confirm the power is off to the water heater.

Youll need to shut off the power to the water heater and remove the covers to the heating elements. Now let us get started with the following steps on how to test a water heater with multimeter. Move to the thermostat terminals and check if it is supplied with power.

If it is you will have a reading of 240V on terminals 1 and 3. Using a multimeter youll need to check the element for continuity. The heating element is a commonly repla.

Easy quick tutorial video on how to test a hot water heater element using a multi-meter. First turn off the breaker in your main electric panel to the water. Water heater isnt heating or heats poorly.

How To Test Water Heater Element